How to replace flint?

Lighter manufacturer flint is also one of the consumables used by lighter manufacturers. Generally speaking, one to two months of normal use will consume a lighter manufacturer's flint. If you practice tricks, the lighter manufacturer's flint will be consumed. Faster. With the use of the lighter manufacturer's flint will become shorter and shorter, so the pressure between the lighter manufacturer's flint and the lighter will not change. The friction will also become smaller, and the sparks will naturally decrease accordingly. Therefore, if the flint is not replaced when the lighter manufacturer is almost exhausted, it will affect the lighter manufacturer’s one-time ignition rate and simply wear the stone holder, and then damage your lighter manufacturer. The general specific process is as follows
1. Open the upper cover of the machine to the maximum angle, hold the lower cover of the lighter manufacturer with one hand, and hold the windbreak wall with the other hand, and pull out the inner bladder forcefully. Turn the inner tank upside down and use a screwdriver or coin to unscrew the screw at the bottom of the inner tank.
2. After unscrewing the screw, take out the screw, flint spring and thimble from the lighter manufacturer, replace it with a new flint from the lighter manufacturer, and install it back as it is.
3. Finally put the inner bladder into the outer shell, thus completing the job of replacing the flint of the lighter manufacturer.
Assuming a sudden drop in the ignition rate, it may be possible to observe that the sparks burned out are significantly reduced, and it is necessary to consider whether it is necessary to replace the flint of the lighter manufacturer.