Summary:Usually, the lighters we use are plastic lighters of one dollar. This lighter is broken and has no s...
Usually, the lighters we use are plastic lighters of one dollar. This lighter is broken and has no significance for maintenance, so I will not talk about the maintenance of this lighter. I mainly talk about the maintenance of high-end
windproof lighters.
First. The lighter is filled with gas, and liquid will be ejected when the lighter is pressed. Lighter is not easy
Ignite: The main reason is
1. The purchased lighter gas is unqualified
2. The gas temperature of the lighter is too low
3. After the lighter is filled with gas, it should be placed at a temperature close to body temperature and then ignited.
If pressing or producing liquid is mainly caused by the above two reasons.
4. It may be that the flame adjustment knob of the lighter is too large. It is recommended to reduce it and try again.
Solution: Change the lighter gas
Second, the main reasons for the leakage of lighters during the inflation process:
1. The design defect of the lighter is that the sealing rubber ring of the inflatable hole is too small.
2. It may be that the quality of the gas tank of the purchased lighter is not good, and it was mistaken for a lighter gas leak during the inflation process.
Solution:
Find a new valve core, then use scissors or a blade to cut a section of about 1mm laterally and place it in the lighter inflatable hole to re-inflate it again to check for air leakage. If the gas cylinder leaks, it is recommended to buy high-quality lighter gas.
Third. The lighter ignites intermittently when pressed repeatedly:
1. This reason is mainly caused by the lighter circuit.
Piezo block used for too long
The aging elasticity of the built-in spring is not enough to generate enough electricity when the hair collapses.
Piezoelectric
The block's phone line moves during prolonged use.
When using a lighter
If the time is too long, the ignition wire end of the piezoelectric block will be burned too much.
Solution: It is recommended to replace the piezoelectric block
Fourth, the main reason why the lighter cannot be ignited by repeated pressing is mainly due to the failure of the circuit and gas circuit
Causes:
1. Circuit reasons.
During the long-term use of the piezoelectric block, its voltage line is constantly rubbed against the lighter body, and its insulating layer becomes thinner and thinner, and finally it breaks down, resulting in a short circuit with the lighter body discharge.
Solution: replace the piezoelectric block, or insulate the voltage line.
